Replacement Stop Cock Valve Recommendation for 1/4 inch Fitting
Question:
I dont know how to measure to be sure I get the right stop cock replacement for the 25 year old rusted/corroded piece. The hex head is 9/16, the brass threads are roughly 1/2, the plunger stem is roughly 3/8, and the girl at a local hardware store looked at it and said I needed a 1/4inch piece??? Thanks.
asked by: Bill
Expert Reply:
If you do indeed need a 1/4 inch drain valve the part # CAM11663 would be the correct one for you.
I went out into our warehouse to measure this and found that the larger threads are 5/8 in diameter, the hex head is 3/4 of an inch wide, the smaller second set of threads is 1/2 inch in diameter and the threads are 9/16 inches wide.
With the outside fitting removed from this it should work for you.
Products Referenced in This Question
Camco Water Heater Drain Valve Replacement - 1/4"
- Accessories and Parts
- RV Water Heaters
- Valves
- 1/4 Inch
- Drain Valve
- Camco
more information >
Product Page this Question was Asked From
Camco Water Heater Drain Valve Replacement - 1/2"
- Accessories and Parts
- RV Water Heaters
- Valves
- 1/2 Inch
- Drain Valve
- Camco
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: Replacement Awning Options for a 21 Carefree Spirit FX Awning
- Q&A: Awning Arms For Use with Solera XL Roller Assembly
- Q&A: How to Adjust Self-Adjusting Trailer Brakes
- Q&A: Water Heater Valve Replacement and Galvanic Corrosion Possibility
- Q&A: Camco Water Heater Drain Valve Replacement For 1/2" Plastic Drain Plug On Water Heater
- Q&A: Side Marker Lights That Can be Used as Turn Signal on Trailer
- Q&A: How to Store Camco CAM40043 Inline Water Filter Between Uses
- Article: RV Pre-Departure Checklist
- Article: How to Clean RV Water Heater