Does Lens have to be Adjusted to Maintain Beam Shape if Utility Light 507-12 is Not Level
Question:
I would like to mount two of these lights on the sides of my tractor hood. Would I have to rotate the lens in the housing 90 degrees to get the proper trapezoidal light pattern? Is this possible?
asked by: Tad B
1
Helpful Expert Reply:
Yes, you would have to change the position of the lens in utility light # 507-12 to maintain the shape of the light beam as if it were mounted level. Though it may be easier to move where the bracket is mounted on the light housing.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Peterson PAR 36 Work Light w/ Mounting Bracket - Trapezoid Beam - Rubber Housing - Clear Lens
- Work Lights
- Flood Lights
- Work Lights
- Exterior Lights
- Round
- Pedestal Mount
- Trapezoid Beam
- Incandescent Light
- White
- Peterson
more information >
Continue Researching
- Q&A: Power Awning Conversion Kit for Carefree Fiesta BN3N4
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Horse Trailer Wiring
- Q&A: Are Two Wires Required to Install the Clear Utility Light # 507-12 on a Trailer
- Q&A: Replacement Interior Lamp for 2008 Exiss Sport Horse Trailer
- Q&A: Does Skid Plate of 2014 Toyota FJ Cruiser Have to Come off to Install Curt Front Hitch
- Q&A: Recommendations for a Trailer Mounted Utility Light for Night Boat Docking
- Q&A: How Tight Should Spindle Castle Nuts be Tightened
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: How to Use a Roof Rack (Like a Boss)
- Article: What are the Common Types of Propane Fittings Used on RVs?