Does an LED Third Brake Light Require a Load Resistor
Question:
Does the third brake light using putco plasma led need a load resistors for a 1994 ford f150
asked by: Josh T
1
Helpful Expert Reply:
The only circuits that need load resistors are the ones that flash when the blinkers or hazards are on.
A third brake light circuit would not require a load resistor like the part # DI34ZR that you referenced.
expert reply by:
Jameson C
1
![Jameson C](https://images.etrailer.com/static/images/catg/people/371_tn.jpg)
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Continue Researching
- Q&A: LED Tail Lights Added to Flat Bed Truck Hyper Flash with Flashers/Turn Signals On
- Q&A: Distance From Corner of Bed to Gooseneck/5th Wheel on Flatbed Truck
- Q&A: How to Find Best Height Setting for Demco Recon Gooseneck-to-5th Wheel Recessed Ball Hitch
- Article: Gooseneck to 5th Wheel Adapters
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Load Resistor Recommendation for Preventing Hyperflash Range Rover Towing Trailer w LED Taillights
- Article: Trailer Wiring Diagrams
- Q&A: Adding Furrion RV Air Conditioner to Replace Vent with Fan
- Q&A: Load Resistors to Allow Wiring Harness to Operate with LED Trailer Lights
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Q&A: Replacement Light for Optronics Red Clearance Light 20327-02
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
John
6/4/2020
2006 Honda Ridgeline, I bought led third brake light but not plug and play, what do johnny need to buy to convert them to work without splicing