2 inch Rise Ball Mount Recommendation that is 10 inches from Ball Hole to Pin Hole
Question:
Im looking for a class III ball mount with a 2inch rise and 9-10inch length center-to-center for my 2007 Toyota RAV4 11inch height loaded with my Wells Cargo RoadForce 5x8 trailer 16inch road-to-top-of-ball. Can you suggest one? The Curt C45230 is almost right, its just a little tight on the clearance due to its length. Thanks.
asked by: Gary S
Expert Reply:
The part number # C45230 would be your best option. This ball mound will do 2-3/8 inches of rise which would be close enough for your setup most likely when you take into account a bit of sag from the weight of your trailer's tongue weight.
The ball mount is 10-1/4 inches from the center of hitch pin hole to center of ball hole as well.
For a 2 inch ball the part # 40038 would be what you need and for a 2-5/16 inch ball part # C40007.
Products Referenced in This Question
2" Hitch Ball - 1" Diameter x 2-1/4" Long Shank - Chrome - 12,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 2-1/4 Inch Shank Length
- 1 Inch Diameter Shank
- 12000 lbs GTW
- Class III
- CURT
more information >
2-5/16" Hitch Ball - 1" Diameter x 2-1/4" Long Shank - Chrome - 10,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2-5/16 Inch Diameter Ball
- 2-1/4 Inch Shank Length
- 1 Inch Diameter Shank
- 10000 lbs GTW
- Class III
- CURT
more information >
Product Page this Question was Asked From
Curt Dual Length Ball Mount for 2" Hitches - 2-3/8" Rise, 3-5/8" Drop - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 1 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 3 Inch
- Rise - 2 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Class III
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Can a Trailer Ride With the Tongue at an Upward or Downward Angle
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Will Rock Tamers Mudflap Heat Shield Protect Flaps from Melting
- Q&A: How Do I Know How High The Ball Should Sit Above the Ground
- Q&A: Hitch Pin Hole to Weld Area Dimensions on Curt Dual Length Ball Mount for 2" Hitches
- Q&A: Can Roadmaster Anti-Rattle Hitch Extender be Used for Towing Travel Trailer
- Q&A: What is the Ideal Height for a Ball When Towing a U-Haul Trailer?
- Q&A: Adding A Rooftop A/C Unit To An Enclosed Trailer
- Article: Hitch Adapters and Extenders
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Anti-Rattle Devices
- Article: How to Choose a Bike Rack for a Motor Home or RV