Y Bow Stop Recommendation with 3 inch Base
Question:
I need a Y style bow stop that has a 4span with a 3inch or 3 1/2inch base. The pin bore is 1/2. Have a hard time coming close to this. The bow of the boat comes to a sharp point and the previous bow stop was wearing on the boat. I repaired and reinforced the bow. Now I need a proper stop. Any suggestions would help. Thanks
asked by: Ryan S
0
Expert Reply:
The closest thing we offer that may work for you is the part # YR6Y33-4. This has a 3 inch base, takes a 1/2 inch shaft, but has a span of 6-1/2 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Yates Y-Style Bow Stop for Boat Trailers - Heavy-Duty Rubber - 6-1/2" Span - 1/2" Shaft
- Boat Trailer Parts
- Guards and Pads
- Bow Stop
- 2-7/8 Inch Wide
- Black Rubber
- 3 Inch Long
- Fits 1/2 Inch Shaft
- Yates Rubber
more information >
Continue Researching
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Article: Trailer Tire Sizing
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Q&A: Size of U-Bolt Slots in Dutton-Lainson # DL21742 Roller Bunk Bracket for Roller Bunks DL21740/41
- Q&A: Kodiak Disc Brakes For 3,500 lb Axles on Travel Trailer
- Q&A: How to Select Replacement Hub for Harbor Freight Trailer
- Q&A: Wider Trailer Wheel and Tire Recommendation for PWC Trailer in Sand
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
- Article: How to Raise Your Travel Trailer Height
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Boat Trailer Guides: Which are the Best?
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Brake Controller Installation on a Ford Full-Size Van