bing tracking image
Summer Starts Here - Save up to 70%
SAVE NOW
Customer Service My Orders
Q & A Icon

Brake Controller Recommendation and Install Harness Recommendation for 2010 Dodge Ram  

Question:

Tekonsha Brake Controller - 90195 Would this work on my 2010 Dodge ram 1500 ?? Would the harness that comes with it be the correct one also??

0

Expert Reply:

If your 2010 Dodge Ram 1500 has a factory 7-way at the rear of it all you would need is the install harness part # 3021-P to install the Prodigy P3 brake controller part # 90195.

Otherwise you would need to start with a 4-way if you didn't have one, part # 18252 and then go with the part # ETBC7 to convert the 4-way to a 7-way and install the controller.

If you have a 4-way already you would instead need the controller, the # 3021-P, and the # 37185.

Usually located under the driver's side of the vehicle, right behind the front wheel well is a wire connector. As you can see in the picture there are more wires on the hood side (right side) of the connector than the hitch side. Using a circuit tester you can locate the wire that supplies power to the trailer brakes. Usually it is the blue one. Using a quick-splice, run a wire lead from the blue wire to the back of the vehicle. Enough wire will be needed to make it from the front wheel well to the end of the truck bed.

expert reply by:
0
Jameson C
click to enlarge
Ask The Experts a Question >>

Products Referenced in This Question





Product Page this Question was Asked From


Featured Help Information

Instructions

Instructions for 18252Instructions for 3021-PInstructions for ETBC7Instructions for 90195

Miscellaneous Media

dbc
Electric Brake Controller Installation on Dodge Ram Trucks to 2012
etbc7
Brake Controller 7- and 4-Way Installation Kit (ETBC7)
Trailer Brake Controller Installation - 2001 Dodge Ram
Trailer Brake Controller Installation - 2001 Dodge Ram - Video
Q & A Icon

Continue Researching

See More Q&A Expert Answers >>