Troubleshooting Scissor Jack that Won't Lower When Nut is Turned
Question:
Jack is in the up position trying to bring it down the nut gets loosen but the Jack does not come down I already tried spraying it with WD 40 and it did not help
asked by: Vivian
Expert Reply:
Are the threads of the main screw turning while the nut is being turned? If so and the jack isn't moving it could be that the barrel nut on the opposite end of the scissor jack has become stripped and now does not allow the jack to raise or lower.
If the main screw isn't turning then the problem is that the nut of the screw has some how disconnected from the screw. Either way it sounds like it's time for a new set of scissor jacks. The part # UF48-979032 that you referenced should work well for you. We haven't heard of any issues like this.
Product Page this Question was Asked From
Ultra-Fab Ultra Scissor Jack - 30" Lift - 6,500 lbs
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 6001 - 7000 lbs
- Scissor Jack
- 30 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Angle of Different Stabilizer Positions for Ark Drop Down Corner RV Stabilizer Jacks
- Q&A: Can Ark Drop Down Stabilizers Be Extended And Retracted With A Power Drill
- Q&A: Solution to Replace WFCO 8735P to Charge Lithium Batteries
- Q&A: Wiring Diagram for Lippert Stabilizer Jack # LC298707
- Q&A: Replacement 3 Terminal Rocker Switch for RV Stairs
- Q&A: Replacement For Dexter DX12.5 Brake Actuator on Boat Trailer
- Q&A: Where to Measure on a Scissor Jack to Determine if it Will Fit on a Trailer
- Article: Stability Control for Heavy Duty Vehicles
- Article: Must-Have Flat Towing Components
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: How to Measure for Motorhome Steps
- Article: Trailer Wiring Diagrams
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size