Troubleshooting Brake Controller that Stopped Working With Brake Pedal
Question:
I have power to the controller can activate the trailer brakes manually with a result of them working, I have no signal reaching the factory plug under the dash from the brake switch. I jumped, temporary hard wired the signal wire from the brake switch and the controller worked. Is there a relay between or am I looking at a bad wire?
asked by: Jay
0
Expert Reply:
It sounds like you have a bad third brake light (CHMSL), fuse and because of that your brake controller has stopped working. Replacing the fuse should fix the problem and get your controller back going.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Availability of InvisiBrake Installation Video on 1998 Jeep Wrangler
- Q&A: Replacement for Pollak PA66-MD40 Connector
- Q&A: Recommended Flat Towing Setup for a 2016 Jeep Wrangler Using a ReadyBrute Elite II Tow Bar
- Article: Flat Towing Package for 2011 Chevrolet HHR
- Q&A: Does B and W Gooseneck Hitch # BWGNRK1217 Fit 2017 Nissan Titan XD Long Bed
- Q&A: Blule Ox Baseplate For A Diesel 2020 GMC Sierra 3500 Denali
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Q&A: How To Mount Pollak Connector PA66GF30