Base Plate Kit Needed for Flat Towing a 2008 Dodge Dakota

Question

Question:

I have a falcon 2 hitch on my toad, I want the same base plate for a dodge dakota. Only the base plate is needed plus hardware. Then I can tow the Saturn or the Dakota with the same hitch.

asked by: Jimmie T

0

Expert Reply:

The Roadmaster EZ Base Plate Kit, item # 52276-1, is the correct fit for your 2008 Dodge Dakota.

You may need wiring to safely flat tow your Dakota. The Roadmaster Universal Hy-Power Diode Wiring Kit, item # RM-154, would be a good choice and if you do not want to splice into the vehicles tail light wiring the RoadMaster Tail Light Wiring Kit with Bulbs, item # RM-155.

expert reply by: Robert G

0

Answer 1

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 2

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 3

Yes, your 2017 Chevrolet Equinox FWD can be flat towed with all 4 wheels on the ground. Do understand that you will need to run your Equinox for 5 minutes every time you stop for gas to properly lubricate your transmission and before towing. A better…

view full answer...

Answer 4

Gladly! The difference between the Blue Ox Patriot 3 Radio Frequency, Portable Braking System BRK2019 and the Blue Ox Patriot Radio Frequency, Portable Braking System #BLU37TR is that the Blue Ox Patriot 3 RBRK2019 is older, no longer available, and…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The instructions for the Demco Tabless Base Plate Kit #DM77YV are being added to page but I'll also send them to you separately. In the instructions they only show that the air dam needs a chunk cut out and that the shutters would remain. The…

view full answer...

Answer 7

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 8

Although it's not said, to install the Demco Tabless Base Plate Kit #DM77YV there may be some trimming of spoiler, air dam, grille or plastic fascia required depending on the model of this vehicle. To complete your flat towing setup, you're…

view full answer...

Answer 9

Hey Michael, The Falcon 5250 has direct-connect attachment points that hook onto a crossbar, if you remove the crossbar adapter then you'll be able to go with a direct-connect baseplate like the #RM77ZR (models with tow hooks) or #RM76RR (models…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

2024 models of the Chevy Equinox have the same steps listed as the 2023 models to get the vehicle ready to flat tow: 1. Position the vehicle to be towed and secure it to the towing vehicle. 2. Start the vehicle. 3. If equipped with AWD, engage the…

view full answer...

Answer 12

Hello Curtis. You can absolutely use an RV mount tow bar with your 2006 Ford E350 Van. For example, the Blue Ox Avail Non-Binding Tow Bar #BX7420 is compatible with any 2" hitch receiver. This could be on a motorhome, van or pickup truck. As…

view full answer...