How Far Apart Are The Bolt Holes On The Fulton Pro Series Round, A-Frame Jack, # PSEA20000103
Question:
how far apart are the bolt holes?
asked by: Brandon E
0
Expert Reply:
On the Fulton Pro Series Round, A-Frame Jack, # PSEA20000103, the bolt holes on the triangle mounting flange are 3 inches from center of one hole to the center of the next hole.
They are equally spaced apart and they are elongated for easier installation.
expert reply by:
Jeff D
0
Product Page this Question was Asked From
Pro Series Round, A-Frame Jack - Topwind - 14" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 14 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Pro Series
more information >
Continue Researching
- Q&A: A/C Unit Recommendation for my Enclosed Trailer With Heat Strip
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Rear Brakes on a 2022 Montana High Country 5TH Wheel Locking Up
- Q&A: What is the Difference Between the AirLift Wireless Compressor Systems 73000EZ & 74000EZ
- Q&A: Determining the Best Top and Side Trim Options for an Enclosed Trailer
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Q&A: Troubleshooting Trailer Brakes that are Adjusted that Feel too Weak
- Q&A: Troubleshooting Trailer Brakes On A Barrett Gooseneck Trailer
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Which Brake Assembly Does Part Numbers B10E-21 & B10E-22 Correspond to?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Jacks
- Article: Double-Eye Trailer Suspension System Review