Troubleshooting Curt T-Connector Wiring Harness # C56078 Installation on 2010 Hyundai Santa Fe

Question:

I have installed the wiring harness in my sante fe 2010 and I am at wits end why it doesnt work. The install was quick and easy, but when I hooked it up to the trailer I found one side not working, and only a flasher working on the driver side, but not all the time. I check all the wiring in the trailer, I cleaned the flat bar connector of the trailer and still no change. I went out and bought a new set of lights for trailer thinking there might be a break or something in the lines. I re hooked up the trailer and it made no difference. I borrowed dads car and hooked it to trailer and everything worked fine. I figured it must be the converter box, I bought another wiring kit for the car and installed that, again no difference, Do you have any suggestion why its not working? I put a tester on the flat bar connecter and it shows only power going through for the driver side flasher. Any help is appreciated...

asked by: Brian B

Expert Reply:

From the issues that you are describing and the troubleshooting that you have already done, it really sounds like it is a ground issue to me.

I recommend taking a piece of sandpaper and sand down the area where your ground is connected. You want bare metal to bare metal contact.

Although I am pretty certain that this is the issue, please send me an email if this doesn't correct the problem and we can go over some additional troubleshooting steps.

expert reply by: Leah S