Installation Instructions for Junior Locking Steel Flush Door Latch # L1980
Question:
I purchased a set of these paddle locks to complement an existing storage cabinet with multiple doors. My mistake was not checking the mounting method. My other paddle locks have four welded studs on the inside corners of the flashing that fit through the door. Just how do these paddle locks mount? There are no mounting holes or mounting studs.
asked by: Gene T
0
Expert Reply:
The Junior Locking Steel Flush Door Latch, # L1980, could be welded to your storage cabinet or you can secure the latch by drilling holes in the housing and use pop rivets.
expert reply by:
Leah S
0
Product Page this Question was Asked From
"Junior" Locking Steel Flush Door Latch
- Trailer Door Latch
- Latches
- Flush Latch
- Steel
- Built In Lock
- 2-3/4 x 3-3/4 Inch Cutout
- Redline
more information >
Continue Researching
- Q&A: Does the Buyers Products Rotary Latch Have a Deadbolt
- Q&A: Replacement for Dexter Grease Seal 010-019-00
- Q&A: Replacement Grease Seal for National 413470 Seal
- Q&A: How to Wire Two 6-Volt Batteries In Series to Double Output Voltage
- Q&A: Recommended Flush Door Latch for Wells Cargo Trailer
- Q&A: Where is Brake Controller Install Connector for 2022 Jeep Grand Cherokee 4xe
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: What Exactly is Tongue Weight?
- Q&A: Offfset Latch for DEF and Fuel Tanks
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: RV Electrical Power Systems
- Article: 7 Common Questions Everyone Has About Trailer Tires