Tube Diameter of Bulldog Replacement Swivel Jack Pipe Mount # BD500399
Question:
I am wondering if this will fit a into 2inch diameter male pipe welded to my trailer? I cant find measurements in the description
asked by: Juan
0
Expert Reply:
The inside diameter of the Bulldog Replacement Swivel Jack Pipe Mount is 2 inches, the outer diameter is 2-1/2. This mount is designed to mount onto a trailer, and accept the female pipe mount on a swivel jack.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Bulldog Replacement Pipe Mount for Swivel Jack - Weld On - 5/8" Pull Pin
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pipe Mounts
- Bulldog
more information >
Continue Researching
- Q&A: Can a Trailer With a 50MM Coupler Be Safely Towed With a 1-7/8" Hitch Ball?
- Q&A: Extended Bracket Height of Bulldog Square Swivel Jack # BD190758
- Q&A: How Should the Safety Chain Attachment Loop part # E950 Attach to Trailer Hitch
- Q&A: Fuse Location for Factory Integrated Brake Controller on a 2011 GMC Sierra
- Q&A: Will Bulldog Replacement Pipe Mount for Swivel Jack Work with My Trailer Jack
- Q&A: How to Wire Trailer Brake Magnets
- Q&A: Can the Replacement Atwood Master Cylinder 85736 Still Be Obtained
- Article: Determining Trailer Tongue Weight
- Article: How Does a Trailer Hitch Coupler Work?
- Article: Wiring a Tow Vehicle to Tow a Dinghy
- Article: Trailer Tire Sizing
- Article: Trailer Jacks
- Article: Trailer Wiring Diagrams
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
Bill C.
6/18/2020
This is actually to mount on a Bulldog jack welded on either a round tw 158 style or a sq jack that is also 2-1/4". this is the female connector side and the male side would be welded to the trailer male size is 2" o.d. this is 2" I.D. would be nice to have the 2-1/4" listed on drawing. AS for the original question this goes on the Outside of your 2" Stub as it is female.