bing tracking image
Q & A Icon

Troubleshooting No Voltage on Blue Wire After Being Connected to Trailer Brake Wires  

Question:

Hello, I have current going right back to the axle but when the wire is hooked up to the brake wires all current disappears. Goes from 9ish volts down to 0 as soon as I touch the blue wire to the brake wiring. Could this be a ground? Ive checked and both grounds on either tire and they seem fine. Keep in mind the wiring is a nightmare in this trailer, I just bought it and lots of little surprises. 1978 Beachcomber. Thanks

0

Expert Reply:

I spoke with my technical contact at Tekonsha, and some brake controllers, like the Voyager, # 39510, will function exactly like you are describing. You'll want to connect the wires and have a helper use the manual override on your brake controller and then test the wire. The current should have reappeared.

If you still have no power, please send me an email with your brake controller information and we can go over additional troubleshooting steps.

expert reply by:
0
Leah S

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>

^

Recently Viewed Products

About Us
photos and videos
1,056,204
Original Photos & Videos

Produced to make sure you know what you are getting and you get exactly what you need.

installations
35,570
Installations Completed

To make sure products work and fit the way they are supposed to.

etrailer call center
2,476,511
Phone Calls & Emails Answered

1,125,924 phone calls and 1,350,587 emails to help find the right solution.

etrailer training
400+
Average Hours of Product Training

We get to know our products firsthand so experts can better help you.

etrailer service
78
Years of Quality Customer Service

Assisting our neighbors and customers, face to face at the counter.

etrailer experts
193,357
Pages of Expert Information

Created to make sure you have all the answers to your questions, from real experts.