Will Curt Weight Distribution Adjustable Shank Work With Pro Series Weight Distribution System
Question:
Will this work with pro series round bar weight distribution
asked by: Brad
0
Expert Reply:
Yes, the shank will fit the Pro Series round bar weight distribution systems. The Curt Welded Weight Distribution Shank, part # C17123 you asked about is designed to fit a 2 inch hitch receiver opening and will work with a weight distribution system that has the industry-standard head.
This shank has a maximum rise of 12-3/4 inches and a maximum drop of 8-1/2 inches and has a weight capacity of 15,000 lbs.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Curt Welded Weight Distribution Shank 7" - 10 Hole Adjustment
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- 1500 lbs TW
- 15000 lbs GTW
- Fits 2 Inch Hitch
- Round - 8 Inch Drop
- Trunnion - 8 Inch Drop
- Round - 12 Inch Rise
- Trunnion - 11 Inch Rise
- CURT
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can Trailer Weight Capacity Be Increased by Changing One Trailer Axle
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Replacement Drop Shank for the Curt TruTrack Weight Distribution System Part # C17500
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Calculating Portable Generator Power Needs
- Q&A: How To Measure To Make Sure The MORryde CRE3000 Equalizers Will Fit Your Trailer
- Q&A: Equal-I-zer Weight Distribution Shank that has More than 3 Inches of Drop
- Q&A: Extending Curt Weight Distribution Hitch to Clear Electric Tongue Jack
- Q&A: Replacement Bearings for Dexter 8-222 Hub
- Q&A: Should Hitch Ball Angle Be Adjusted Up and Down or Angled to the Rear Using Weight Distribution