New Amber LED Lights Flicker on a 2000 Cadillac Escalade
Question:
I have a 2000 cadillac escalade i rplaced my front turn signal bulbs with flashback led bulbs this is a three wire socket i also have an electronic flasher and resistors hooked to the turns signals the problem im having is the turn signals work fine but when the bulbs are lit up white going down the road they will keep flickering or turning on and off
asked by: Daniel
Expert Reply:
It sounds like there is a bad connection or ground or there isn't a load resistor on the running light circuit, Usually load resistors are used to cure hyper flash on a turn signal. But since LED lights draw such little power it could be that another load resistor is needed such as # DI34ZR. This is especially true if it is happening on both sides. If the issue was one side I would say there is a loose connection or bad ground.
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Continue Researching
- Q&A: Solution for Rapid Signal Flashing on Utility Bed with LED Lights
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Q&A: Are Load Resistors Needed for LED Backup and Brake/Tail Lights
- Q&A: What Is The Depth Of The Ventline Pinnacle Ductless RV Range Hood VE78SR
- Q&A: How Do I Install Load Resistors for the LED Lights on my 2007 Dodge 3500 Flatbed
- Q&A: Recommended Load Resistor Adapter for Furrion Observation Camera on Travel Trailer for Signal
- Q&A: AC Shroud Replacement for Coleman Mach 7333A887
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Trailer Wiring Diagrams
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Best Boat Accessories
- Article: Which Hitches are Made in the USA
- Article: Most Popular Wheel Bearings
- Article: 5 Things to Know About Weight Distribution Hitches