Trimming Of Heat Shields Required When Installing Trailer Hitch On 2015 Honda Accord Hybrid
Question:
I purchased a hitch for my 2015 Honda Accord sedan Hybrid. There were no notes in the specs about the Hybrid, but when I went to install the hitch the passengers side frame was inaccessible due to shielding. My conclusion is that the Hybrid is not able to accept the sedan hitch. Can you please confirm this?
asked by: Steven B
Expert Reply:
I checked out the installation instructions for the Curt Trailer Hitch, part # C11681 that fits your 2015 Accord.
Per the instructions, in step 2 the heat shields on both sides will need to be removed and trimmed to allow installation of the hitch. On page 6 of the instructions there is a trimming diagram that shows the measurements for the trimmed area on the shields. As the instructions state, one of the fasteners will not be used when re-installing the shields.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Vehicle Air Mattress
- Video: Best 2013 Honda Accord Hitch Options
- Video: Trailer Hitch Installation - 2015 Honda Accord - Curt
- Video: Best 2013 Honda Accord Trailer Wiring Options
- Video: Best 2015 Honda Accord Hitch Options
- Video: Trailer Hitch Installation - 2013 Honda Accord - Curt
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Video: Choosing the Right Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: 44649
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Search Results: 68149
- Article: Trailer Wiring Diagrams
- Shop: Brake Controller
- Search Results: 25580
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Search Results: dust cap
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Article: Trailer Tire Sizing
- Shop: Fifth Wheel Hitch