What Draw Bar Fits Draw-Tite Class I Hitch Part # 24812
Question:
I have 3 - 1 1/2 drawbars. How can I tell if they will fit in the #24812 hitch? Is there a measurement of the pin hole location for this hitch?
asked by: paul r
Expert Reply:
The Draw-Tite Class I hitch you were looking at, part # 24812 uses a 1-1/4 inch receiver. A class I hitch usually has a stop welded into the receiver tube or a detent punched into it to prevent a class II accessory from being used. If the draw bars you have were intended to be used in a class I hitch, they will work.
Keep in mind, Draw-Tite recommends only using the part # 3593 draw bar. If the draw bars that you have measure any longer than 1-1/2 inches from the center of the pin hole to the back end of the bar, it will not slide into the receiver far enough for the pin holes to line up.
Products Referenced in This Question
Draw-Tite Drawbar for 1-1/4" Hitch - 2-1/8" Rise, 2-3/4" Drop - 6-5/8" Long - 2K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 3 Inch
- Rise - 2 Inch
- Fits 1-1/4 Inch Hitch
- 2000 lbs GTW
- Class I
- Draw-Tite
more information >
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Q&A: Is Hardware Included with Draw-Tite Hitch 24812?
- Shop: Draw-Tite Drawbar for 1-1/4" Hitch - 2-1/8" Rise, 2-3/4" Drop - 6-5/8" Long - 2K
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Hitch Receiver Sizes
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Recommended Hitch for a 2024 Subaru Legacy
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Which Way Do the Washers Install On the Curt Hitch C12228
- Article: Determining Trailer Tongue Weight
- Q&A: What is the Difference Between Class 1 and Class 2 Hitches for the Scion XB
- Q&A: Parts Needed to Tow Trailer with 2007 Toyota Matrix
- Q&A: Is A 2 Inch Trailer Hitch Available For A 2009 Toyota Camry