Brake Controller Wiring Harness for a 2010 Ford F-150 and P3 Brake Controller
Question:
I plugged the prodigy three into the factory connector with the cable that came with the brake controller and the vehicle 2010 F150 would not operate. I did notice that the pin locations on the provided assembly was different from the cable provided with the vehicle so I spliced into the factory provided cable and the brake controller worked fine. Ergo: the cable provided with the brake controller seems to be incorrectly pinned. Should I ask for a replacement or can the cable be repinned? Thank
asked by: John C
Helpful Expert Reply:
For a 2010 Ford F-150 and Tekonsha brake controller you should be using harness # 22292. The harness that comes with the brake controller is a generic one that is used for hardwiring applications.
The end of harness # 22292 that plugs into the truck should look like the picture I have included. If all of the wires on the harness you are using are on the same row then that is the harness for the Super Duty models and not the F-150.
The wires can be moved by releasing the locking tabs on the sides of the connectors and using any small, narrow, and flat tool to remove the wires/pins and then relocating them to match 22292.
Products Referenced in This Question
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trailer Hitch and Wiring Confirmed to Fit the 2024 Toyota Grand Highlander
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Recommended Plug and Play Adapter to Install a Brake Controller in a 2024 Ram 2500
- Q&A: Replacement Disc Brake Caliper for a Tie Down Engineering 46304 Caliper
- Article: Trailer Wiring Diagrams
- Q&A: Where are Connectors on 2014 Dodge Ram 1500 that Are Used to Install Brake Controller
- Q&A: Grease Seal Fit based on Inner Diameter and Outer Diameter
- Q&A: Replacement Actuator for a TDE Model LP7000
- Q&A: Where Does Red Wire of Brake Controller Install Harness 3023-P Install on 2014 Ram 2500
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Curt Echo Full Review