Outer Diameter of Center of 3.5K Trailer Hub/Drum Assembly with 5 on 4-3/4 Bolt Pattern
Question:
I was hoping to find out what size the wheel center bore needed to be to fit over these hubs. Every other measurement was there, just not that one.
asked by: Don-f
Expert Reply:
I went out to the warehouse to measure hub and drum assembly # 845476UC3 for you. The outer diameter of the center of the hub (where the wheel pilot hole will fit around) is 2.60 inches. Just a hair less than 2-5/8 inches.
This will only matter if 1) the wheel pilot hole is too small or 2) if a wheel secures to a hub using wheel bolts instead of lug nuts. Since this hub/drum has studs of lug nuts the pilot hole on the wheel can be larger, just not smaller.
Product Page this Question was Asked From
Dexter Trailer Hub and Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 4-3/4
- Trailer Hubs and Drums
- Hub with Integrated Drum
- Standard
- L68149
- L44649
- For 3500 lbs Axles
- 5 on 4-3/4 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Replacement Trailer Hub and Drum and Brakes for AL-KO 8490 Axle
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Recommended Spare Tire Carrier for Utility Trailer with Angle Iron Frame
- Q&A: Replacement 10 Inch 5-on-5 Bolt Pattern Brake Drums for Old Car Trailer
- Q&A: How to Determine the Size of a Trailer Hub Assembly for Replacement
- Q&A: Correct Replacement for Shelby 5101 A-Frame Trailer Coupler
- Article: Ram Trailer Tow Prep Package
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Q&A: Replacing 10x1-1/2 Inch Brake Assemblies with 10x2-1/4 Inch Brake Assemblies
- Q&A: Measuring Bolt Pattern On Drum Assembly
- Article: Printable Trailer Bolt Hole Pattern Template