Quick Connector 2-Way Availability for Installing a Trolling Motor
Question:
do you have a cable connector so i can just connect my minn kota outboard engine trough comfort conectors. so the cable that comes from my engine has a comfort connector at the end. the cables attached to my engine is open eyelet connector. in advance thank you.
asked by: Piet H
Expert Reply:
It sounds like you are looking for an easy to connect and disconnect 2-way wiring connector that you can use to install your trolling motor. If 16 gauge wire is adequate you could use the part # HM47965 for this. You would need to cut the wires in the middle of the harness and then wire each side in the middle of the power and ground wires for the trolling motor.
Products Referenced in This Question
Hopkins 2-Pole Flat Wiring Extension - 12" Long
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 0 - 5 Feet Long
- 2 Pole
- Plug and Lead
- 2 Pole
- Hopkins
more information >
Product Page this Question was Asked From
CTEK Comfort Connect M6 (6.4-mm) Spare Battery Cable
- Accessories and Parts
- Battery Charger
- Cables
- Spare Battery Cable
- CTEK Power Inc
more information >
Continue Researching
- Q&A: Replacement Battery Terminal Cable for CTEK Multi US 3300 Charger
- Q&A: Should I Use Leaf Spring Spacers Lift Blocks on a Trailer to Raise It