Drill Adapter for BAL Industries Trailer Stabilizing Jacks
Question:
Will this adapter fit BAL Light Trailer Stabilizing Jacks? The outside diameter of the jacks screw shaft is about 5/8.
asked by: Adam
0
Expert Reply:
The BAL jacks use a 3/4 inch hex head bolt so Ultra-Fab adapter # UF48-979071 would not fit. Instead you would use # UF48-979005.
expert reply by:
Michael H
0
Products Referenced in This Question
Ultra-Fab Speed Socket Power Drill Adapter for Scissor Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Tools
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Ultra-Fab T-Slot Power Drill Adapter for Scissor Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Tools
- Ultra-Fab Products
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Crank for Atwood Electric Trailer Jack
- Q&A: Replacement Propane Tank Cover For A 2005 Trail Lite Hybrid Trailer
- Q&A: Replacement Foam Ring for Ventline Vanair Trailer Roof Vent Part # VP-543SP
- Q&A: What is the Retracted Length of the Tubes on the Landing Gear Set RVLG-8000
- Q&A: What Is the Warranty of the Landing Gear Set with Handle RVLG-8HDL
- Q&A: Installation of SoftStartRV Soft Start on Dometic 3105052.041
- Q&A: Replacement Stabilizer Jack Need for Lippert Model 113407
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Maintenance Schedule
- Article: How to Survive the Winter In Your RV