Dimensions Of Mounting Stud On Optronics LED Trailer Clearance, Side Marker Light
Question:
Hi Everyone! What is the diameter and length of the mounting stud. Is a lock nut and washer included and if not the nominal size. Thanks!
asked by: Hal
1
Helpful Expert Reply:
The mounting stud diameter on the LED Trailer Clearance, Side Marker Light, part # MCL95AB measures 5/8 inches long and is 1/4 inch diameter. This comes with the nut and washer needed to install on your trailer.
This is a single-wire design light. The mounting stud also doubles as the electrical ground. I have attached a link to a video you can check out.
expert reply by:
Jeffrey L
1
Product Page this Question was Asked From
Optronics LED Clearance or Side Marker Light - Submersible - 3 Diodes - Rectangle - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 2L x 1W Inch
- Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement For TDE LP75 Disc Brake Actuator
- Q&A: How to Connect Trailer Safety Chain Hooks to Ford F-150 Factory Safety Chain Loops
- Article: Trailer Maintenance Schedule
- Q&A: Can Red Identification Light Bar be Used as Marker & Reverse Lights
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Replacement Hub/Drum for Lippert 8k Hub 2420801
- Q&A: Replacement for Wesbar 102641 Tail Lights
- Q&A: Recommended Flat Towing System for 2017 Ford Explorer FWD with 3.5L
- Q&A: Recommended Gauge of Wiring for Trailer Lights