Can Ultra-Fab Power Electric Stabilizer # UF39-941707 Be Disconnected and Used as Separate Parts
Question:
Dear Etrailer, I have a follow up question, Can this system be disconnected and used separately / installed seperately or does the Center piece have to be connected? Sincerely
asked by: Thomas D
0
Expert Reply:
The Ultra-Fab Power Twin II Electric Stabilizer # UF39-941707 is a dual-motor stabilizer intended to operate as a single unit. If installed as separate halves without the center support it would not be able to deliver its intended performance and could be damaged in use. That center support in some applications may need to be bolted to your trailer frame as noted in the linked instructions.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Ultra-Fab Power Twin II Electric Stabilizer for Trailers and RVs - 22" Lift - 6,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Travel Trailer
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV
- Q&A: Cover for GR-9994 Propane Cover
- Shop: Replacement Motor for Ultra-Fab Power Twin II Electric Stabilizers
- Shop: Replacement Electric Jack Waterproof Switch with Harness for Lippert High Speed Stabilizer Jacks
- Shop: Lippert High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit - 30" Lift
- Q&A: How Many Amps Does 1 Motor Draw on the Ultra-Fab Power Twin II Electric Stabilizer
- Video: Lippert Components Trailer Jack LC352338 Review
- Q&A: Does the Center Support On the Valterra RV Sewer Hose Carrier 50-94 Inches Need To Be Installed
- Shop: Automatic Glass Cartridge Fuse Kit - 5 Amps to 30 Amps - 60 Pieces
- Shop: Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors - 30" Lift - 6,000 lbs
- Shop: Ultra-Fab Power Twin II Electric Stabilizer for Trailers and RVs - 22" Lift - 6,000 lbs
- Q&A: Replacing Motor on Lippert Stabilizing Jacks Due to Water Intrusion
- Q&A: Can I Bypass Lippert Stabilizer Jack Switch To Test Switch Functionality
- Q&A: Lippert Stabilizer Jack Troubleshooting Breaker Resets
- Q&A: Wiring Diagram for Lippert Stabilization Jack LC298707
- Search Results: lippert landing gear
- Search Results: fuses
- Shop: Propane Adapter Fitting - 1/4" Female Inverted Flare x 1/4" Male NPT
- Search Results: lippert stabilizer switch
- Search Results: ultra~fab products
- Video: Buyers Products Trailer Wiring Junction Box Review
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Search Results: fuse
- Search Results: ultra fab rear electric stabilizer
- Search Results: lippert stabilizers