5th Wheel Trailer Landing Gear Motor Strains and Gear Box Makes Noise and Shakes
Question:
I have a 2008 Dutchman Colorado 29BH. When raising the camper, the motor will start out fine and then it starts to strain a bit. When the motor starts to strain, the gearbox starts to clunk and shakes around a little bit. I replaced the electric motor, but the new motor is also doing the same thing. Is this a sign that the gearbox is going bad? It only does it when I am lifting the camper. If I am retracting the legs, it works fine. This part#: LG-179015 looks like the one I have on the camper already. Will it fit?
asked by: AW
Expert Reply:
It could be the gear box or it could be damage to the screw or nut inside the jack leg(s). If you have a Stromberg Carlson, Atwood, Lippert (LCI), or Venture landing gear system then # LG-179015 will fit.
If you replace the gear box and still have the problem then I suspect there is a problem inside one of the legs and it will have to be replaced. For a replacement lead leg # LG-179013, rated for 3,000 pounds, is a likely fit. There is also a repair kit for this leg, # LG-146059.
The matching follower leg is # LG-179014 and its repair kit is # LG-146060.
Products Referenced in This Question
Lead Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Follow Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Replacement Lead Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Stromberg Carlson
more information >
Replacement Follow Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gearbox
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Troubleshooting Powered Landing Gear that Clicks But Does not Raise/Lower
- Q&A: Troubleshooting Landing Gear on 2008 Montana Mountaineer Edition 345DBQ Fifth Wheel
- Q&A: Replacement Landing Gear Motor for a ADTH E226168
- Q&A: Replacement Motor and Gear Box for Landing Gear # ADTH 1RV-200 on Keystone Everest
- Q&A: Difference Between 8,000 lb Landing Gear RVLG-8HDL & RVLG-8000
- Q&A: Replacement Landing Gearbox for 125340 Motor on a 2008 Montana Mountaineer 35 foot 5th Wheel
- Q&A: 5th Wheel Landing Gear Motor Comparison for Part Number From LCI 142178
- Article: Best Landing Gear
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: How to Replace an RV Roof Vent Cover
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Service An RV Air Conditioner
- Article: Brake Controller Installation: Starting from Scratch