Wiring the Pollak Metal 7-Pole # PK12703 by Function to a Vehicle When Wire Colors Dont Match
Question:
What if you dont have a red wire running from the truck
asked by: Sherry
0
Expert Reply:
When you wire up the Pollak Metal 7-Pole # PK12703 you will want to wire it by function and not by color necessarily.
The red wire you referred is for the left stop/turn circuit. Your truck may not have this color wire for this function so you would need to use a circuit tester like part # PTW2993 to determine which wire on your vehicle is for that circuit and then wire it to this connector. Use the diagram I attached as a guide.
expert reply by:
Jameson C
0
click to enlarge
Products Referenced in This Question
Product Page this Question was Asked From
Pollak Metal 7-Pole, RV-Style Trailer Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Do 8k Oil Bath End Caps On Lippert Axle Interchange With Dexter End Caps
- Q&A: Recommended Electric Over Hydraulic Brake Set Up for 2016 Montana 3710FL 5th Wheel
- Q&A: Replacement Grease Seals For TRP GS-1719DL
- Q&A: Is Adapter Needed to Install Dometic Water Heater # DMC74FR In Place of Atwood
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Q&A: Recommended Wet Bolt and 2-1/4" Shackle Strap Kit for Tandem Axle Trailer
- Q&A: Recommendation for Installation of a Brake Mounting Flange on a Trailer Spindle and Axle
- Q&A: Do I Need Brakes On Both Axles of a Car Hauler Trailer?
- Article: Hitch Adapters and Extenders
- Article: Troubleshooting Brake Controller Installations