Location Of Port On 2012 Cadillac SRX With Factory Tow Package To Install T-One Wiring Harness
Question:
I have a 2012 SRX. Where do I plug this connector?
asked by: Ken
Expert Reply:
The port that you plug the T-One Vehicle Wiring Harness, part # 118259 into is located behind the rear bumper above the place a hitch would be installed. This harness is designed for vehicles that have a factory tow package.
I have attached a link to an installation video for this harness on a 2012 SRX you can check out. At the 10 second mark on the video it shows where you can find the port you need to connect the harness.
If you do not have the factory tow package, you will need to hardwire a harness like part # C59236. I have attached a link to an installation video for this harness.
When working with electrical connectors I recommend using dielectric grease like part # 11755. This keeps dirt and moisture out of the electrical connections and helps prevent corrosion.
Products Referenced in This Question
Dielectric Grease for Electrical Connectors, 2 oz.
- Accessories and Parts
- Trailer Wiring
- Wiring
- Dielectric Grease
- LubriMatic
more information >
Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Universal Fit
- 4 Flat
- CURT
more information >
Product Page this Question was Asked From
T-One Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Curt vs. etrailer Trailer Hitch For 2016 Cadillac SRX
- Q&A: Recommended 2 Inch Trailer Hitch for a 2013 Cadillac SRX
- Q&A: How To Install A Curt Hitch and A Brake Controller On A 2010 Cadillac SRX
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Q&A: How to Tell if a Vehicle has a Tow Package or Not
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can you Use a Standard Pin and Clip with the etrailer Cargo Carrier
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Can the Center Knockout Panel be Re-Installed After a Trailer Hitch on a 2015 Cadillac SRX
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Ram Trailer Tow Prep Package