Why Would There be Rattle Between Trailer Coupler and Hitch Ball
Question:
Hi. I have a rattle between my existing 2inch hitch ball and Shelby 2inch coupler, which is annoying when the trailer is lightly loaded. Would this Titan unit allow for a tighter fit between the hitch ball and coupler? Also is this unit American-made?
asked by: Chris S
Expert Reply:
If your current coupler is loose enough that it rattles when connected to a hitch ball it is in need of adjustment or replacement. There should be a nut on the underside of the coupler that holds the latch in place. You would want to tighten that down so that the latch fits tighter to the hitch ball.
The Titan Coupler part # T4845000 would also be a great replacement as long as your trailer frame is built on 3 inch channel. This coupler is also made in the USA.
Product Page this Question was Asked From
Dexter Zinc-Plated, Leverlock Coupler - 2" Ball - 3" Channel - Bolt On - 5,000 lbs
- Straight Tongue Trailer Coupler
- Standard Coupler
- 2 Inch Ball Coupler
- Bolt-On
- 5000 lbs GTW
- 3 Inch Channel
- Trigger Latch
- Dexter
more information >
Continue Researching
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Rhino Rack Roof Rack Recommendation for 2008 Chevy HHR
- Q&A: Parts Needed to Flat Tow 2023 GMC Yukon XL Denali
- Q&A: Is There a 14 inch Version of Aluminum Viking Series Valhalla Trailer Wheel
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Installation of Slipper Spring with Open Eye End
- Q&A: Brake Controller Installation on 2016 Mercedes-Benz Sprinter
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)