Gauge of Wire Used in the Waterproof, Over 80" LED Trailer Light Kit # TLL16RK
Question:
Hi, Im looking at buying Optronic led trailer light kit # TLL16RK. Can you tell me what gauge wire the 25foot harness is? Thanks
asked by: Peter G
0
Expert Reply:
According to Optronics the gauge of wire used in the Waterproof, Over 80" LED Trailer Light Kit with 25' Wiring Harness # TLL16RK is 20 gauge. This may seem like a very light gauge (it is), but when you consider that these lights are LEDs which draw a very small amount of amperage it is more than adequate.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
LED Combination Trailer Tail Lights - Submersible - Driver and Passenger Side - 25' Wire Harness
- Trailer Lights
- Tail Lights
- License Plate
- Rear Clearance
- Rear Reflector
- Side Reflector
- Stop/Turn/Tail
- Rectangle
- Kit
- Surface Mount
- Submersible Lights
- LED Light
- 8L x 3W Inch
- Red
- Optronics
more information >
Continue Researching
- Shop: LED Combination Trailer Tail Lights - Submersible - Driver and Passenger Side - 25' Wire Harness
- Q&A: Compatible 6 Lug on 5-1/2 Inch Bolt Pattern Idler Hub and Total Drop of Timbren Axle-Less Suspension
- Q&A: Over 80 inch Wide LED Trailer Taillight Kit for 1998 Shorelander Boat Trailer
- Shop: Dexter Trailer Idler Hub Assembly for 3,500-lb E-Z Lube Axles - 6 on 5-1/2 - Pre-Greased
- Search Results: shorelander
- Search Results: four winns
- Shop: Optronics LED Mini Clearance or Side Marker Trailer Light - Submersible - 2 Diodes - Amber Lens
- Shop: Trailer Idler Hub Assembly for 6,000-lb Axles - 6 on 5-1/2 - Pre-Greased
- Search Results: hub
- Shop: UltraThin LED ID Light Bar for Trailers over 80" Wide - Submersible - 3 Diodes - Red Lens
- Shop: Hopkins Trailer Breakaway Kit with Built-In Battery Charger - Side Load
- Shop: Hopkins 7-Way RV Style Connector w/ Molded Cable and LED Test Lights - Trailer End - 8' Long
- Search Results: boat trailer wiring harness
- Q&A: Will Bargman Lights Fit on Rounded Corners of Boat Trailer
- Q&A: LED Trailer Taillight and Wiring Kit for Military Trailer
- Q&A: Lighting Requirements for Trailer that is over 80 inches in Width
- Q&A: Replacement Trailer Taillight and Wiring Harness for Boat Trailer 4 Winns 180
- Q&A: Will Peterson LED Identification Light Bar # M191-3RL Fit Nitro Boat Trailer
- Article: Trailer Lighting Requirements
- Video: Review of Peterson Trailer Lights - Clearance Lights - M191-3RL
- Search Results: tl16rk
- Search Results: 7 blade wire tester
- Video: Optronics Sealed Rectangular LED Identification Trailer Light Installation
- Video: Optronics Trailer Lights - Clearance Lights - MCL914R1PG Review
- Video: Trailer Wiring and Light Replacement Demonstration
- Video: Deka Wiring 12-2-1 Review
- Video: Optronics Trailer Lights - Clearance Lights - MCL97RPG Review
- Video: Reese Wiring - Wiring Adapters - 78118 Review
- Shop: Trailer Hitch
- Search Results: 58000
David K.
4/11/2020
The answer to an earlier question about wire gauge indicated the wire was 18 gauge for the TLL16RK. This answer states that it is 20 gauge. Which is correct?