What Jack Legs will the Replacement Landing Gear Lead Leg # LG-179013 Replace  

I recommend replacing your lead leg with one that has the same dimensions as your new follow leg, the Replacement Lead Jack w/ Drop Leg #LG-179013. This leg is 29-1/2" long, 2-1/2" wide, has a 4,000 lb weight capacity and can be used with…

Yes, for your landing gear leg that has a sticker that says VMC900R the part #LG-179013 is the correct replacement lead leg.

The Stromberg Carlson Replacement Lead Jack w/ Drop Leg #LG-179013 that you referenced, is a direct replacement part for jacks from Stromberg Carlson, Lippert and Atwood. It is very likely that Forest River used landing gear from one of these…

To determine if the Landing Gear #RVLG-8000 will fit your 20110 Keystone Cougar you first need to determine the distance between the weld stops on your current gear. If your weld stops (see attached picture) measure 15-1/2" on the inside and…

I have exactly what you need to replace the driver's side (lead) landing gear leg on your trailer. Based on the 29-1/2" outer tube and 17-1/2" weld stop measurements, you are going to want to use the Replacement Lead Jack w/ Drop Leg…

Repair kit #LG-146059 contains 2 pins and the drive shaft all of which are for the top of the jack. To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions. The…

We offer replacement driver- and follow-leg kits for many brands of 5th wheel landing gear. The linked page will display all landing gear replacement parts including these two specific items as well as many others. As an example, for the popular…

That's a great question. The jacks sit in the 5th wheel frame mounted clips so that the tab on the upper end of the jack leg sits under the clip, and the tab on the lower end sits above the clip, as shown in the diagram on the right-hand side of…

Sounds like you are looking for just the lead leg for the landing gear you have on your trailer. Since I do not know what landing gear you have on your trailer I attached a link to a page that has all of the lead legs we offer. You would want to…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…