How to Install Curt T-Connector Vehicle Wiring Harness# C55418 on 2002 Toyota Sienna

Question:

I rcvd your trailer hitch and wiring harness. Do you offer a video for installing the wiring harness?

asked by: GARY C

Expert Reply:

We sure do! I've linked you to the installation instructions as well as to an install video.

In a nutshell, you'll remove the rear threshold and pull back the trim panels on either side of the cargo area so you can access the back side of the taillight assemblies. You'll unplug the vehicle wiring harness from the taillight assembly, plugging the half of the harness with the YELLOW wire inline between the taillight assembly and the vehicle wiring harness on the driver's side. Route the half of the harness with the green wire across to the passenger side, using the area under the threshold to route the wires. This would also plug inline with the connection between the vehicle harness and the taillight assembly. You can see the entire procedure by viewing the video.

expert reply by: Mike L