Can Handle on Bulldog A-Frame 3,000 Pound Trailer Jack be Moved to Opposite Side
Question:
Can I change the crank handle from the front to the back of the post? Is it difficult or recommended?
asked by: Wesley R
0
Expert Reply:
It is not recommended to change the configuration of the handle relative to the rest of Bulldog trailer jack # BD1550101344. But what you can do is turn the whole jack and bolt it back down again to move the handle.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Bulldog Round, A-Frame Jack - Sidewind - 13" Lift - 3,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 2001 - 3000 lbs
- Sidewind Jack
- 13 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Is a Support Plate Needed When Installing Bulldog A-Frame Trailer Jack # BD1550101344
- Q&A: Determining Which Trailer Fender Size is Needed
- Q&A: Replacement for a Fulton Marine Trailer Jack Model 0926012
- Q&A: Replacement for a Fulton Marine Trailer Jack Model # 0926012
- Article: How to Charge a Dump Trailer Battery
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Trailer A-Frame Tool Box that Can Hold Propane Tanks that are 19 inches Tall
- Q&A: Shipping Weight of Dexter Trailer Axle T20BTR-EZ-7258
- Q&A: Troubleshooting Bulldog Electric Jack Operating in Reverse
- Article: Trailer Lighting Requirements
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Best Ladder Racks