No Output From Wire Harness Converter On 2006 Toyota Tacoma
Question:
I cant get the signal or brake lights to work out of the converter, I have checked the input to the converter, but I dont get an output, I have a good ground
asked by: Scott
0
Expert Reply:
If you are using a circuit tester like part # PTW2993 and finding that you have a signal going into the converter and not coming out, chances are that the converter is bad and needs to be replaced.
This harness is designed to adapt your tow vehicle's 3-wire, separate taillight system to the trailer's 2-wire, combined system.
expert reply by:
Jeffrey L
0
Products Referenced in This Question
Product Page this Question was Asked From
Hopkins Tail Light Converter with 4-Way Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- 6 Feet Long
- Universal Fit
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Keep LED Turn Signal Lights on Toolbox From Flashing with Brake Pedal Pressed
- Q&A: How Much does the Gen-Y # 325-GH-1625 Weigh?
- Q&A: Converting From 7-Way Round to 7-Way Flat Connector
- Q&A: Latch Repair Kit For Bulldog A256 2-5/16" Ball Latch Coupler
- Article: Most Popular Wheel Bearings
- Q&A: Recommended RV Door Latch for 5" x 5" Opening
- Q&A: Recommended Air Bags for 2022 Ford F-250 Super Duty with B&W Underbed Gooseneck Trailer Hitch
- Q&A: Installation of Coupler Repair Kit # CP02-050
- Article: Trailer Wiring Diagrams
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Trailer Lighting Requirements
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)