LG-1 Landing Gear Repair Kit Recommendation and Install Diagram

Question

Question:

I ordered this kit to do repair can you email directions, or diagram to look at. To repair this leg kit thanks for the help.

asked by: Dan

1

Helpful Expert Reply:

The correct repair kit for the # LG-1 lead leg is part # LG-146059 and for the follower leg it's part # LG-146060. I attached a diagram that shows how these kits will install.

expert reply by: Jameson C

1

click to enlarge

Answer 1

You should need repair kit #LG-146059 for the lead leg and #LG-146060 for the follower leg. From the picture you sent in I was able to determine that you have a Venture landing gear set VMC900R.

view full answer...

Answer 2

Yes, the jack leg part #LC241846 that you referenced does measure 2-1/2 inch by 2-1/2 inch.

view full answer...

Answer 3

Thanks for the photo as well as the description you offered. The Follow Jack Repair Kit for Stromberg Carlson Landing Gear #LG-146060 is the correct fit for your 2010 Coachmen Brookstone 341RE.

view full answer...

Answer 4

Installing the P3 brake controller #90195 on your 2015 Chevy Silverado 2500 with factory integrated controller will actually be very simple. What you will do is use harness #3016 which plugs into a port on the truck already. But you will need to…

view full answer...

Answer 5

On an RV-style 7-way vehicle connector like the one included in our #ETBC7 kit you purchased (thank you) the brake light signals are carried on the same two wires as the turn signals. The contact pins for these right- and left-side functions are at…

view full answer...

Answer 6

We absolutely carry replacement gears like the Lippert Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear #LC146060 which will work with Lippert Components powered landing gears, which is the most common landing gear used however…

view full answer...

Answer 7

You might be able to get something like a center punch and tap it as much as possible at an angle. That could drive enough of it out the other side to be able to grab it with some pliers or vice grips. Another possible method would be to get a…

view full answer...

Answer 8

Thank you for the photo but trailer manufacturers do not keep any type of database with specific part numbers that we can access; even if they did it would not be a guarantee that the parts would be the same on a trailer that was made 20 years ago.…

view full answer...

Answer 9

Thank you for the photo of your trailer landing gear interior. We can help you with a repair kit for the lead and follower legs of your Venture landing gear. For a lead leg repair kit use #LC146059 and for the follow leg use kit #LC146060. It is hard…

view full answer...

Answer 10

The landing gear looks like a standard set based on the pictures and the dimensions you listed. The part #LC146060 would be what you need for the follow leg and then part #LC146059 for the lead leg.

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

LG-1 Landing Gear Repair Kit Recommendation and Install Diagram

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching