Installing a Light and Grommet On Trailer Troubleshooting
Question:
I removed the two lights and rubber grommets off of my utility trailer to paint the trailer and I dont know how to put them back into the oval hole.
asked by: Mike
0
Expert Reply:
Without knowing exactly what light assemblies you have on your trailer it's a bit hard for me to say exactly how to reinstall them, but for the most part you will want to install the grommet first on the trailer and then slide the light into place after similar to the video I attached.
You will see in the video that our installer used a bit of grease on the inside of the grommet to help the light slide into place easier.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics Trailer Tail Light - Stop, Turn, Tail - Submersible - Incandescent - Oval - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Oval
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 6-1/2L x 2-1/4W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement For TDE LP75 Disc Brake Actuator
- Q&A: Replacement Tail Light For Bargman 6-1/2 Inch Oval Light
- Q&A: Where Is the Brake Controller Plug On a 2021 Ford F-150
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Q&A: Replacing A 125255UC Double Lip Grease Seal
- Q&A: Direct Replacement Oval Stop Turn and Tail Light for a Model J-60 Trialer Light is the # ST70RB
- Q&A: What is the Difference Between the Under-Bed Rail Kit # RP87FR and # RP39FR on My 2021 Ford F-350 SD
- Article: Trailer Lighting Requirements
- Q&A: Can I Weld on a Bolt on Brake Actuator?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps