How to Test Brake Switch to Find Circuit to Use for Brake Controller Installation
Question:
the blue trailer brake wire to the brake light switch must have 6 wires coming out of the switch dont know which wire to tap into looking for wiring dia. to find brake light wire thank you
asked by: Paul M
0
Expert Reply:
The easiest and most reliable way to determine which wire of your brake switch wire is the correct one to use is to use a circuit tester like part # PTW2993 to test all of the wires for voltage when the brakes are applied and none when released.
It sounds like you are wiring up a brake controller so I attached a help article on brake controller hardwiring for you to check out as well.
expert reply by:
Jameson C
0
Products Referenced in This Question
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Availability of InvisiBrake Installation Video on 1998 Jeep Wrangler
- Q&A: Replacement for Pollak PA66-MD40 Connector
- Q&A: Recommended Flat Towing Setup for a 2016 Jeep Wrangler Using a ReadyBrute Elite II Tow Bar
- Article: Flat Towing Package for 2011 Chevrolet HHR
- Q&A: Does B and W Gooseneck Hitch # BWGNRK1217 Fit 2017 Nissan Titan XD Long Bed
- Q&A: Blule Ox Baseplate For A Diesel 2020 GMC Sierra 3500 Denali
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Q&A: How To Mount Pollak Connector PA66GF30