Dexter Spindle Washer For 1998 Kiefer Trailer
Question:
Looking for nut lock washers ,11 tabs outside 1 tab inside. 6 ton axels 12000 pounds 2 1/2 inches outside 1 3/4 inches inside appreciate any help Thanks
asked by: Mario
0
Expert Reply:
We have exactly what you're needing. Part # 5-59 is a tang washer for a Dexter Axle. The ID is 1-3/4 inches, and the tabs are identical to what you describe, and the OD is 2-1/2 inches.
expert reply by:
Mike L
0
Products Referenced in This Question
- Accessories and Parts
- Trailer Suspension Parts
- Hardware
- 1-3/4 Inch Diameter
- 10000 - 15000 lbs
- Washers
- Dexter
more information >
Product Page this Question was Asked From
BTR E-Z Lube Spindle for 2,000-lb Trailer Axles - 1-1/4" Diameter
- Trailer Spindles
- EZ Lube Spindle
- 1-1/4 Inch Diameter
- Round
- For 2000 lb Axle
- TruRyde
more information >
Continue Researching
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Article: Most Popular Wheel Bearings
- Q&A: Where to Find Serial Number of Truxedo Tonneau for Replacement Tarp
- Q&A: Weight Capacity of Dexter P-12 SLR SN: D5287869 Axle
- Q&A: Replacement Hub and Spindle for Dexter 69-46 Axle
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: Which Grease Seal for Trailstar Boat Trailer
- Q&A: Recommended Grease Seal w/ a 1.25 ID and a 1.98 OD
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Maintenance Schedule
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Article: Rust Prevention
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs