Replacement Bow Roller Bracket, Shaft and Roller
Question:
So I have an old boat trailer I need to change the bow rollers on but the shafts are larger than 1/2 in. Theyre about 3/4. I cant find anything anywhere with anything bigger than 1/2 in.
asked by: Dan H
Expert Reply:
We don't have any bow rollers that will fit a roller larger than 1/2 inch in diameter so the best recommendation I could make would be to replace your current setup with something like the part # CE31005PG for a bracket, part # CE10700A for a new roller shaft, and then part # YR300Y for a roller.
Products Referenced in This Question
Roller Shaft with Pal Nuts for Boat Trailer Rollers - Zinc-Plated Steel - 5-1/4" x 1/2"
- Boat Trailer Parts
- Rollers
- Roller Shafts
- 1/2 Inch Diameter
- Zinc-Plated Steel
- 5-1/4 Inch Long
- CE Smith
more information >
CE Smith Bow Roller Bracket for Winch Stands - Pre-Galvanized Steel - 13-3/16" Tall - Bolt On
- Boat Trailer Parts
- Winch Stand
- Roller Bracket
- 13-3/16 Inch Tall
- Galvanized Steel
- CE Smith
more information >
Yates Bow Roller for Boat Trailers - TPR - 3" Long - 1/2" Shaft - Yellow
- Boat Trailer Parts
- Rollers
- Bow Roller
- 3 Inch Diameter
- Thermoplastic - Non-Marking
- 3 Inch Long
- Fits 1/2 Inch Shaft
- Yates Rubber
more information >
Product Page this Question was Asked From
Yates Bow Roller for Boat Trailers - TPR - 4" Long - 1/2" Shaft - Yellow
- Boat Trailer Parts
- Rollers
- Bow Roller
- 3-1/4 Inch Diameter
- Thermoplastic - Non-Marking
- 3-3/4 Inch Long
- Fits 1/2 Inch Shaft
- Yates Rubber
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does The Redline Grease Seal 13194 Have Markings Of TCM 13194 TM and a Spring On The Inside Lip
- Q&A: Weight Capacity of Yates Keel Roller
- Q&A: Dimensions of Mounting Plate and Total Height of Fulton Single Speed Trailer Winch
- Q&A: Could Dutton Lainson Winch Fit Boat Winch Mount that Measures 3 inches Wide and 5 inches Long
- Q&A: Location of Brake Controller Port on 2015 Toyota Tundra
- Q&A: Lug Nut Torque Range for 1/2-Inch Wheel Studs and Steel Trailer Wheels
- Q&A: Recommendation for Replacement Bow Stop Roller Measuring 4 Inches with 1/2 Inch Hole
- Article: Where to Position the Trailer Axle?
- Article: Trailer Wiring Diagrams
- Article: Frequently Asked Questions About Transmission Coolers
- Article: How to Launch a Boat from a Trailer (And Load it Back Up)
- Article: Trailer Tire Sizing
- Article: What is Boondocking
- Article: Determining Trailer Tongue Weight