Distance from Center of Pin to Mounting Surface on the Bolt-On Spring Latch # SL716SS
Question:
On part SL716SS - the bolt on spring latch - I want to know where the center of the hole is on the base for the pin. I just want to know how high the pin sits
asked by: Carly L
0
Expert Reply:
The distance from the mounting surface of the Bolt-On Stainless Steel Spring Latch # SL716SS to the center of the pin is 5/8 of an inch.
I went and pulled one of these from our warehouse to take this measurement.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Bolt-On Stainless Steel Spring Latch
- Trailer Door Latch
- Latches
- Spring Latch
- Stainless Steel
- Non-Locking
- 7/16 Inch Pin Diameter
- Redline
more information >
Continue Researching
- Article: Replacement Automotive Lighting
- Q&A: What is the Difference Between Over 80 inch and Under 80 inch Trailer Tail Lights
- Article: Performance Chips and Modules
- Q&A: Would the Replacement Square End Cap 853-5826 Fit Gorilla Lift GL1
- Article: 2023 Holiday Must Haves
- Article: Trailer Wiring Diagrams
- Q&A: Hooking a Gooseneck Trailer with RV 7-Way Plug to 1999 International 9100 7-Way Round Plug
- Q&A: Converting From 7-Way Round to 7-Way Flat Connector
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Article: How to Replace an RV Roof Vent Cover
- Q&A: Which Fuse In My 2005 GMC Sierra Powers The Trailer Running Light Circuit?
- Q&A: 12 x 2 Inch Electric Trailer Brakes with a 4 Bolt Mounting Pattern
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Slipper Spring Trailer Suspension System Review