E-Track Recommendation to Secure 4 Motorcycles in an Enclosed Trailer
Question:
We will be hauling four motorcycles to Florida from Michigan in a 14foot enclosed cargo trailer with a plywood floor. My plan is to install 9 pieces of short E-Track 3 on each side, and 3 in the middle and secure each piece via the cross members and through the plywood with a metal backing plate. I will then purchase 10 of the Tie off Rings to tie down the motorcycles. Will it be acceptable to utilize one Tie off Ring to attach two straps? where the front of one bike would meet the strap of the rear of the bike in front Attached is a poorly illustrated drawing of my plan, but i feel it explains my question better. Thank you!!
asked by: Dennis H
Helpful Expert Reply:
You would be more than okay to run two tie downs off of one the E-Track Tie-Off Ring part # 59131 that you referenced. Each of these has a 4,000 lb capacity which would be more than enough for what you are doing.
Your plan to use 9 of the E-Tracks # EM59150 with the # 59131 like the drawing you sent in would work perfectly. For backing plates you could use the part # e96RR.
I attached an install video for the E-track for you to check out as well.
Products Referenced in This Question
etrailer E-Track Backing Plates w/ Hardware - Galvanized Steel - 6" Long x 6" Wide - Qty 2
- Accessories and Parts
- E-Track
- Tie Down Anchors
- E-Track Parts
- 6 Inch Wide
- Backing Plate
- 6 Feet Long
- etrailer
more information >
Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 2' Long - Qty 1
- E-Track
- E-Track Rails
- Horizontal
- 5 Inch Wide
- 2000 lbs
- 2 Feet Long
- Erickson
more information >
Product Page this Question was Asked From
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: battery isolator
- Search Results: trailer jack foot plate
- Search Results: battery isolators
- Q&A: How Does Deka Battery Isolator Get Wired?
- Q&A: Replacement Trailer Jack for 2001 Viking Saga 1906 Pop-Up Camping Trailer
- Q&A: Will Trailer Drain Battery If Left Hooked Up To Tow Vehicle Overnight
- Q&A: Preventing Trailer Mounted Battery from Draining Battery on Tow Vehicle
- Q&A: Installing A Battery Isolator On The Trailer Side Of The Wiring Connection
- Article: How to Install E-Track in 3 Easy Steps
- Video: RackEm Spare Tire Carrier Review
- Video: Redarc Smart Start Battery Isolator Manufacturer Demo
- Video: Review of Bulldog Round A-Frame Jack Leg And Pull Pin Assembly - BD500377
- Video: Redarc Battery Chargers - Battery Isolators - 331-SBI212 Review
- Video: Dutton-Lainson A-Frame Trailer Jack Review
- Video: NOCO Commercial Grade Battery Box Review
- Video: NOCO Snap-Top Battery Box with Strap Review
- Shop: Rack'Em Spare Tire Mount for E Track
- Q&A: Where to Put E-Track in Motorcycle Trailer
- Shop: Snap-Top Battery Box with Strap for Group 24 to Group 31 Batteries - Vented
- Shop: Bulldog Round, A-Frame Jack - Topwind - 15" Lift - 5,000 lbs
- Shop: TorkLift HiddenPower Under-Vehicle Battery Mount with Battery Box
- Shop: Deka Battery Isolator - 120 Amp
- Shop: Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 4,000 lbs - White
- Shop: Stromberg Carlson Hitching Post Chain and 7-Way Plug Holder for Trailer Jacks
- Q&A: E-Track Parts to Secure Side By Sides and Dirt Bikes
- Search Results: backing plate
- Search Results: etrack
- Search Results: x track
- Search Results: shocker hitch