Location of Brake Controller Port on 2015 Toyota Tundra

Question:

I have pulled the kick pad, lower dash cover and can not find any pig tail connection. All wires a plugged in and wire gauge looks way too small for any type brake controller connection. How about a picture. What you stated is in the owners manual.

asked by: Vern

Expert Reply:

The brake controller port for the 2015 Toyota Tundra is located behind the section of the dashboard with the tow/haul button. To reach the connector you will need to locate the notch in the access panel in the center of the dash near the driver's side. Using a trim panel puller, carefully pry the panel out and undo the locking tabs to remove the panel. You will find the mating connector behind this portion of your dashboard. Simply plug the Tekonsha Plug-In Wiring Adapter, # 3031-P, into the factory port and plug the other end of the adapter directly into your Prodigy P3 Trailer Brake Controller, # 90195.

I have attached a few pictures as well as installation instructions for you.

expert reply by: Leah S