What is the Curt D-Ring J-705 Made Of
Question:
Is the clasp galvanized/zinc plated or is it raw steel? Just wondering because if it is welded, Id have concerns with welding galvanized/zinc.
asked by: John
0
Expert Reply:
The Curt D-ring, # J-705, is raw steel. It is not zinc plated or galvanized. It is meant to be welded onto another steel surface. Welding zinc or galvanized steel does have challenges and can produce toxic fumes so going with a raw steel component is the way to avoid that.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt D-Ring Tie Down Anchor - Weld-On - 4-3/8" Wide - 6,000 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Tie-Down Cleats and Rings
- 6000 lbs
- D-Ring
- Surface Mount - Weld-On
- CURT
more information >
Continue Researching
- Q&A: Fine Threaded 1/2 Inch Carriage Bolts to Hold Spare Tire to Carrier
- Article: Where to Position the Trailer Axle?
- Q&A: Can Yoke Style Trailer Coupler Be Repaired
- Q&A: Differences Between Demco eZ-Latch Trailer Couplers
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Maintenance Schedule
- Q&A: Firestone Heavy Duty Air Compressor Versus Xtreme-Duty Air Compressor
- Q&A: Recommended 7,500 lbs Air Bags and Compressor for a 2015 Ford F-250
- Q&A: Powering Trailer Mounted Winch from 7-Way Trailer Connector
- Q&A: How Does The Brake On the Dutton-Lainson Hand Winch w/ Automatic Brake # DL15761 Operate?
- Article: Trailer Hitch Receiver Sizes
- Article: How to Wire an Electric Winch
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class