Diameter of the Install Holes of the Ear Mount, Plastic Trailer License Plate Light # LP81BB
Question:
I have a question about LP81BB. What is the size fastener needed for this part to mount?
asked by: Jeremy
0
Expert Reply:
I went out into our warehouse and measured the install holes of the Ear Mount, Plastic Trailer License Plate Light # LP81BB and found them to be 3/16 of an inch in diameter.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Trailer License Plate Light with Housing and Mounting Bracket - Clear Lens - Black Base
- Trailer Lights
- License Plate Lights
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4L x 1-9/16W Inch
- White
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Q&A: Recommended Replacement Drop Leg for a Bulldog Tongue Jack
- Q&A: Bearing/Race/Seal Kit for Boat Trailer w/ NOK AD7131E Seal 25580 Inner and LM67048 Outer Bearing
- Q&A: Best Way to Prevent Sagging Suspension When Towing a Trailer
- Q&A: Replacement for Shelby 5107 A-Frame Trailer Coupler
- Q&A: What is the Standard Bolt Pattern for Pintle Hooks
- Article: Snow Tire Chains Explained: How Tire Chains Work & When to Use Them
- Q&A: Replacement Antenna for Voyager WVCMS130AP Back Up Camera on Airstream International Serenity RV
- Q&A: Lug Nut Nuts for Dexter 10K Axel
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Store a Travel Trailer/Camper for the Winter