How to Extend the Pollak Trailer Connector Adapter # PK12727
Question:
hi this 7-pole to 7-pole cable how long is this cable need a 3 feet ext. cable with same plus as your. my cable on my trailer is to short. if have it I like to now the prize . thank you
asked by: Johnny
0
Expert Reply:
All of the adapters like the part # PK12727 that you referenced would need to be extended in order to be 3 feet long.
To do this you would need to cut the wires and then wire in a length of wire for each circuit so that it is long enough for what you need. I would recommend 10 gauge wire like part # 10-1-1 that is sold by the foot.
expert reply by:
Jameson C
0
Products Referenced in This Question
Product Page this Question was Asked From
Pollak Trailer Connector Adapter - 7-Blade Plug to 7-Pole Round Pin - Nylon
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 7 Round - Blade
- Plug and Lead
- 7 Round - Round
- Pollak
more information >
Continue Researching
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Adapter To Connect to 6-Pole Round Connector To a 7-Pole Trailer Connection
- Q&A: Wiring Diagram for 7-Way Round Pin Trailer and Vehicle Side Connectors
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Torque Specification for Lugs Nuts on 5/8-Inch Stud on Dexter Hub
- Article: 2023 Best Gifts for Haulers & Towers
- Q&A: How to Find Which Trailer Brake Assembly Goes on the Left or Right Side of a Trailer
- Q&A: Troubleshooting Trailer Wiring Install Where Blinkers Activate Both Sides of Trailer
- Article: Trailer Maintenance Schedule
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)