How to Pick Out the Correct Replacement Bearings for a 1995 Coleman Roanoke Trailer
Question:
Coleman Roanoke 1995 Bearings/races/seal. 1 set. What part numbers?
asked by: Walt O
0
Expert Reply:
The only way to determine what bearings you will need to replace the ones in your 1995 Coleman Roanoke trailer is to remove the hubs, pull out the bearings, and then get the numbers that are stamped on the bearings.
Or, if the numbers aren't visible you can use a dial or digital caliper to get a couple exact measurements of your spindle. See the picture I attached for where to measure. Basically, it's where the bearings ride on the spindle.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- Bearing Kits
- Bearing L44649 and L68149
- Race L68111 and L44610
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: What is the Best Grease for Trailer Bearings
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Timken Bearing Kit Fitment for a 3,500 lb Axle
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
- Q&A: Bearing Kit Recommendation for 84 Spindle K71-717-00
- Q&A: Tips for How to Identify a Trailer Axle
- Q&A: Recommended U-Bolts And Plate For A 1-1/2" Wide Square Axle
- Q&A: Lug Nut Torque Chart for Trailer Wheels