How to Install a Prodigy P2 90885 Brake Controller in a 2014 Kia Sorento
Question:
Installing a Prodigy brake controller, where do i route the wires through the firewall?
asked by: Bernd J
Helpful Expert Reply:
To install the wires of the # ETBC7 that get run to the battery of your 2014 Kia Sorento so that you can install the Prodigy P2 Brake Controller part # 90885 you will need to look for a grommet or knockout in the firewall to route the white brake wire into the cab. If none is available, you can drill a hole on a section of the firewall where there is no obstruction on either side. You will need to drill a hole to install a grommet # SWC8055 large enough for the 3 wires that will pass through.
I attached an install video to the right that shows a # 90885 being installed in a similar vehicle that requires drilling into the firewall.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Snap Bushing Grommet - 7/16" ID, 9/16" OD
- Wiring
- Wiring Protection
- Bushing Grommet
- 7/16 Inch Diameter
- Spectro
more information >
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Where Do the Wires on the Universal Install Kit for Trailer Brake Controllers Get Installed?
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Q&A: Should I Get a Proportional or Time-Delayed Brake Controller
- Q&A: Parts Needed to Tow Trailer With Brakes Using 1992 Dodge D250
- Q&A: 4-Flat Trailer Wiring For 2024 Jeep Wrangler With Tow Bar Wiring