Solder Spool - 1/16"

See what our Experts say about this Flint Hill Goods Electrical Tools

• Which is Preferred Connection for SMI CoachLink 900 Wireless Transmitter
  The SMI CoachLink 900 Wireless Transmitter and Receiver Braking Indicator Set # SM99945 that you mentioned comes with a couple butt end connectors and a couple quick splices for tapping into a circuit. I personally don't care for quick splices as the few times I've tried to use them I either ended up cutting the circuit I was trying to tap into or didn't press the blade hard enough to get the circuits to contact. The best connection would be to solder it. For that we have the part # FL0803490...
  view full answer...
• What is the Best Method to Attach Brake Controller Red Wire to Stop Light Wire on Brake Switch
  The best way to make the connection from the red wire on a brake controller to the stop light circuit on the brake switch is to solder in the red wire to the stop light wire. You will need to be careful not to overheat and damage the vehicle wire or surrounding wires when soldering. If you need solder you can # FL0803490. It would then be a good idea to wrap the connection in electrical tape. The next best option is to use a Scotch-Loc if your 2010 Honda Pilot does not have a tow package...
  view full answer...
• Replacement Wiring Harness with Upgraded Circuit Protection for a 2007 Ford Escape
  Since you are experiencing trouble with the plug and play wiring harness, # 118426, I would recommend that you go with an Upgraded Heavy Duty Wiring Harness w/Integrated Circuit & Overload Protection, # C59496. This harness has a newer design which automatically resets if a short circuit or overload is detected, once the short circuit or overload is resolved. When installing the Upgraded Heavy Duty Wiring Harness, # C59496, on your 2007 Ford Escape you should follow the directions for...
  view full answer...
• Is It A Good Idea To Solder RVS Camera Splice Kit
  For the Rear View Safety Splice Kit # RVS-SPK01 I think that is a great idea, soldering them together and protecting them with heat shrink will guarantee they are connected properly while protecting the connection from damage. To accomplish this, if you do not already have the tools you need, you can use a soldering iron like the Cordless Soldering Iron # PTW2000 and a solder spool like Solder Spool # FL0803490.
  view full answer...
• How to Wire a License Plate Bracket with a Light on a Dune Buggy
  License plate lights are typically wired to the running light circuit. You should have no problem wiring your plate light in with your existing tail lights. I recommend using solder, # FL0803484, and a soldering iron for these connections, but a quick splice, # SWC502905-1, will work if you do not have access to a soldering iron. A circuit tester, # 3808, will be needed to locate the running light circuit on the dune buggy. Typically it is easiest to find this circuit at the rear of the...
  view full answer...
• Troubleshooting Dim Trailer Tail and Brake Lights when Connected to a 1993 Jeep Grand Cherokee
  This sounds like a weak ground connection on the vehicle side trailer connector. Make sure that the ground is attached to a clean and corrosion free bare metal surface. There should be no paint or corrosion where it is grounded. If it is attached to a common ground then you might have better luck moving it to a ground by itself. Also make sure that the trailer connector is clean and free of corrosion inside and out. If you feel that the wiring connectors installed on your vehicle are inferior...
  view full answer...

Do you have a question about this Electrical Tool?