The Longview Custom Towing Mirrors # LV97RR has both the driver and passenger side towing mirrors included in the price. These custom-fit towing mirrors will slide onto your 2019 Chevrolet Colorado's existing mirrors to expand your field of vision. They have a tool-free installation, the included arms hooks to the inside edge of the factory mirror and tighten into place with a hand knob. view full answer...
You won't want to cut a jack like the Square Direct Weld Jack # TJD-8000, with the issue being that doing so you would cut the lift rod inside the jack, not to mention void the warranty, and compromise its capacity. So I would avoid doing that, though I can sympathize with your issue, as 4 or 5 inches is pretty low.
There isn't an absolute minimum standard for how high off the ground a jack should be, but generally you want a jack to be about 8 inches off the ground to ensure clearances... view full answer...
I contacted the manufacturer about the wattage draw of the Hook Probe Circuit Tester # PTW2993. They told me that the circuit tester will pull at least 5 watts. view full answer...
On your 2007 Chevrolet Colorado it will have either came from the factory with a 7-way trailer connector or with no trailer connector. The models that had the 7-way trailer connector will have had all the factory wiring and fuses necessary for a 7-way trailer connector to function the trailer lights and charge line on a connected trailer. If your Colorado came with the factory tow package you will have this wiring unless it was removed by a previous owner.
The Colorado's without the 7-way... view full answer...
The Rear View Safety Blind Spot Sensor System # RVS-BES02 for your 2022 Chevrolet Colorado will have 2 indicators for a vehicle or object in your blind spot. The first is a light that can be installed in your A-pillar, this will light up when it detects a vehicle in your blind spot. The second indicator is a alarm, it will sound when you turn on your left or right turn signal and it detects that there is a vehicle or object in that blind spot. You will still get the visual indicator that... view full answer...
In order to choose the best weight distribution system for your travel trailer you will first need to know your total tongue weight (TTW), which is the tongue weight of your fully loaded and ready to go trailer plus the weight of any cargo behind the rear axle of your 2017 Chevy Colorado.
The tongue weight is typically between 10% and 15% of your trailer's GVWR but you'll want to verify it by using a scale such as the etrailer Tongue Weight Scale # e99044. From there, simply add on the... view full answer...
There is not an issue with overheating with the Roadmaster Guardian Rock Guard # RM-4000; the only caveat is that some owner's manuals do state not to use a vertical towing shield so you will need to check the manual of your '19 Colorado. If you cannot use a vertical shield then you can use the Roadmaster Tow Defender Protective Screening # RM-4700 for a horizontal shield. Either way, the transmission should not be creating heat when you are flat towing so there will not be an issue with... view full answer...
The cord I recommend that connects your generator to the 30 amp circuit of your RV is part # A10-G30330VP.
This is a 12-inch cord with a 3-prong male connector for the generator and a 3-prong female plug for your RV. view full answer...
Long story short, the # RE94FR DOES provide sway control.
The Reese 49912 Reese Pro Round Bar Weight Distribution which we offer as part # RE94FR offers effective weight distribution for trailers with tongue weights ranging from 400-800 lbs and offers sway control that works great for resisting mild to moderate trailer sway. view full answer...
There isn't a socket size because spindle nuts are not torqued down so sockets are not used; you'll want to use a channel lock or crescent wrench for the spindle nut on the Trailer Axle # e84YR. view full answer...
The Pop & Lock Custom Tailgate Handle and Lock for the 2012 Chevrolet Colorado, part # PAL1700C, cannot accept a replacement lock cylinder of the type and size used for typical automotive keys. I spoke to my contact at Pop & Lock to confirm that this part is not compatible with standard auto lock components.
You might instead want to consider a power lock, since this will avoid the need to keep track of the additional keys. Pop & Lock offers a power custom tailgate lock that connects into... view full answer...
For a 2022 Chevrolet Colorado you only flat tow four-wheel-drive vehicles that have an N (Neutral) and a Four-Wheel Drive Low (4 (n) setting. Look for knob on the dashboard. This will most likely be the last position on the right of the knob and be an "N" that will illuminate when placed in neutral.
First apply the parking brake and start the engine. Then shift the transfer case to N (Neutral). Verify that the vehicle is in N (Neutral) by shifting the transmission to R (Reverse) and... view full answer...
On page 317 of the owner's manual of a 2019 Chevy Colorado it states that failure to disconnect the negative battery cable can cause damage to the vehicle, and this is referring to the electronics of the truck which could potentially be damaged by not disconnecting the battery. The "negatives" of not disconnecting the battery are that the truck's electronic systems will be damaged, and the damage would not be covered by warranty if you did not follow the procedure outlined in the owner's... view full answer...
'How dry' is kind of a subjective term that's pretty hard to define. Let me begin by saying that your average tonneau cover will do a pretty decent job of keeping the vast majority of the water out, but no Tonneau cover is completely waterproof. If you're having a heavy-type rain, chances are some water will infiltrate into the truck bed.
A high quality cover like the BAK MX4 you mentioned will preform better than average in this respect. If you're getting what you consider to be excessive... view full answer...
I checked with the manufacturer and the Curt Trailer Hitch Receiver # C13203 weighs 36-1/2 lbs.
I have added a link to the instructions and a video install for you to check out as well of the Curt Trailer Hitch # C13203. view full answer...
The part you mentioned is a actually manufactured by Pollak, which we sell as part # HM40975. If your Colorado has the factory tow package featuring the US CAR connector under the rear of the vehicle, it would plug directly into the # HM40975.
If you don't have the factory tow package you can still install that connnector, but the US CAR connector won't be present and you'd need to hardwire it using # HM40975-11998, which provides both the pigtail and the connector. The wire colors/gauge... view full answer...
Thank you for your purchase directly from etrailer of the Redarc Tow-Pro Elite Brake Controller # RED44FR. I can only guess as to the issue but can give you a bit of direction; when you disconnect the controller from your Colorado do the brake lights stay on? If they do, you can rule out the # RED44FR being faulty, and it is likely the 12 volt wire and stoplight switch wiring from the controller are shorting out to each other.
Also, it is possible the brake controller was not wired correctly... view full answer...
Tires have a heavy spot and a light spot, so the markings on the tires applied in the manufacturing process, are intended to be a guide for tire technicians so they have an idea of where to mount the tire on the wheel. It's important to point out that trailer tire and wheel combos, like # LHAW124, come assembled this way, which offers sufficient balancing for most trailer applications.
Although not required, you can choose to have the tire/wheel dynamically balanced at a shop, however,... view full answer...
In my opinion, since you already have the OEM hitch on your vehicle, I would not replace it with a square tube hitch, especially if you aren't having any issues with towing. Consumers tow everyday using a weight distribution hitch with a round tube hitch and do just fine.
I consulted with my contact at Cequent, the parent company of Hidden Hitch, Draw-Tite, and Reese, to get their opinion as well and basically the round tube is going to be a little less resistant to torque but as long... view full answer...
The black powder coating on the casing of the Ark Drop Down Corner RV Stabilizer Jack Kit # ARK34FR will last for years but the legs that slide up into the casings are not powder coated, as you can see the product pictures, so they will show metal. view full answer...
Go To Results