Even if your 2007 Saturn Outlook has the same connector that goes with # 118384 it is possible that the connection on the vehicle is not fully functional. The vehicle would have to have come from the factory with a 7-Way trailer connector for # 118384 to work properly.
What you need is the T1 harness, # 118434 that you referenced. This harness plugs in line with each of the tail lights and provides a 4-Way trailer connector. I have included a link to the installation details and a link... view full answer...
It sounds like you have a short in the running light circuit on your trailer.
Each incandescent tail light will pull approximately 2 amps, with the marker lights pulling .05 amps apiece. Your current lighting configuration is not pulling enough amperage to short out the harness or the circuit feeding it.
Typically, the running lamp circuit uses a brown wire. Trace this circuit back from the trailer connector back toward the lamps. Look for pinched wires or spots where the wire insulation... view full answer...
This is a pretty common problem. Even with the brush and penetrating oil the threads are still too gunked up to point the bolts won't thread. You'll need to find a thread tap in the correct size and then clean the threads out with that. The thread size is M12x1.75. view full answer...
It sounds like you might have an issue with your ground, or you may need to simply reset your brake controller now that it has been installed. Once you turn your vehicle on and the trailer isn't connected, there should be a red light that appears on the controller.
To reset your brake controller, unplug the pigtail harness for about five minutes. After that, plug the harness back into the brake controller.
If resetting the controller doesn't work, try grounding the controller to a different... view full answer...
The First thing I would do is make sure that the ground wire from the wiring harness, # 118434, and the ground wire from the Adapter, # 30717, are attached to good ground locations that are free of paint, primer, and corrosion on your 2007 Saturn Outlook.
It sounds like you may have already done this, so once you are sure the grounds on the vehicle are good, make sure the connections between the left side taillight and vehicle wiring harness are fully seated and locked in place. The left... view full answer...
Go To Results