Expert Answers about Isuzu N-Series

• Connecting Brake Controller to 12 Volt Power
• There were no specifics provided in regards to vehicle, brake controller, wiring or wiring adapter so I'll have to be very general. Unless you have a factory 7-way and tow package you will need to first install a 4-way, which is specific to your vehicle, and then the Universal Installation Kit for Trailer Brake Controller # ETBC7. In regards to the power wire, as you can see in the accompanying diagram it is the black wire from the controller (or the controller's harness) which will be...
  view full answer...


• Hardwire Installing Brake Controller In Vehicle That Does Not Have Stoplight Wire
• In situations such as this, you will want to get the stop light signal from a different source. In my research, I was unable to find any vehicle specific information on your 2007 Isuzu N-Series pickup. As long as your vehicle has separate turn and brake light wires, you can splice the stop light signal wire into a brake light wire for the taillight. If your vehicle has a center high mount stop lamp, the CHMSL is a great place to connect the brake controller's stoplight wire. The CHMSL...
  view full answer...


• What Size Fasteners Should be Used to Install E-Track Inside of a Box Truck
• On the E-Track # E19148 the mounting holes are 1/4 inch in diameter so you will need to have fasteners that have a head larger than that, are long enough to go through where you are mounting the track, and are appropriate for the material you are mounting the E-Track to. You will not have to remove the plywood so long as the E-Track is attached to a reinforced part of the wall (frames, support structures, etc.). I have included a link to a video review for you. If you need a backing plate...
  view full answer...